Front Panel - Denon PROFESSIONAL DN-900R Schnellstartanleitung

Playing Back Recorded Files
1. Press Play to start playback.
2. To pause playback, press the
Pause button. When Play is
pressed again, playback will
resume.
3. To stop playback, press the
Stop button.
Features

Front Panel

2
1
3
1. Power Switch: Press this switch to turn DN-900R on/off. The unit will go into Network
Standby mode when powered on for low power operation with network access (if previously
enabled in the System Setting menu). If Network Standby is not enabled in System Setting,
the unit will go into Standby mode without network access when powered on. Make sure the
AC Input is properly connected to a power outlet. Do not turn the unit off during media
recording or playback—doing so could damage your media.
2. Headphone Level: Turn this knob to adjust the level of the headphone output.
3. Headphone Output: Connect headphones to this 1/4" (6.35 mm) TRS output.
4. USB Drive Port: Connect a mass-storage-class USB device to this port.
5. SD Card Slots: Open the security doors to insert an SD/SDHC card into the slot. The doors
can be fastened for security by removing the plastic pin retainers and inserting the included
screws.
6. Shift: Press this button to access secondary functions, printed under each button.
7. Move/Dimmer: Press this button to move the file of the current track. Hold Shift and press
this button to change the brightness of the display and LEDs.
8. Copy/Rec Mon: Press this button to copy the file of the selected track. Hold Shift and press
this button to turn the recording monitor function on/off. Hold Shift and press Copy to turn
the recording monitor on/off. When the recording monitor is turned on, the audio file as it is
being recorded and stored on the media will be heard from the audio outputs. This is useful
to check what the final quality of the recorded file sounds like.
Note: There will be a delay in the audio signal heard through the outputs when Rec Mon is
turned on.
9. Combine/Mark: Press this button to combine the selected track with another track. Hold
Shift and press this button to add a mark to the current playback or recording position.
5
4
7 8 9
6
13
10 11 12
24 23 22 21 20
14 15 16 17 18
19
7