Sensor Assembly - Gewiss CHORUS GW 10 716 Installationsanweisung

INSTALLATION INSTRUCTIONS
The sensor must be positioned flush with the floor so that it can detect the presence of liquids,
in such a position that the LED is well visible and the button accessible. Before definitively fixing
the sensor to the wall it is advisable to check the RF connection with the detector.
To do this requires carrying out the sensor acquisition procedure and a test from the position
where the sensor will be installed (see following paragraphs).
Double fixing possibility:
From above 3-4
NOTE: The first time the product is powered-up or when the "sensor-detector"
communication is particularly DIFFICULT, it is recommended to check during installation
that sensor and detector communicate properly (see "faulty sensor test and
identification" procedure).

Sensor assembly

2
From left-hand side 3-4
4
3
35
1
3
E
N
G
L
I
S
H
4