BMI 4 in 1 Digipeak Bedienungsanleitung Seite 3

Charge Mode
• 1. Main Menu -> press (enter) to start the charge mode.
• 2. Set the current rate before charging. Charge can vary from 300mA-5000mA.
• Default current is 2A. Via + (increase) and – (decrease), the charge rate can be adjusted.
Battery capacity
600mAH
1300mAH
1800mAH
3300mAH
• It is normal if the current of Ni-Cd and Ni-MH battery packs turns to zero after charging.
• An empty (3.0V per cel) LiPo battery pack needs to be fully recharged
with a charge rate of 1C.
• To re-peak the pack, simply press the (Start) button.
• Press (enter) to indicate maximum voltage.
• The cooling fan will work when you press the (Start) button to start charging.
Discharge Mode
• 1. Main Menu -> press (enter) and the + (increase) button to start the discharge mode.
2. Set the discharge current rate. It is adjustable from 0.3A~2.0A.
• The discharge setting can be altered for Ni-Cd and Ni-MH cells, but the voltage for single cells can not
be below 0.8V and for 6cells not below 4.8V.
• End discharge
1.To re-discharge the pack simply press the (Start) button.
2. Press the (enter) button to return to the main menu.
Cycle charge Mode (discharge -> charge)
• Main Menu -> press (enter) and the + (increase) button twice to enter the cycle mode.
Press the (Start) button to start.
• Before entering this mode, charge/discharge rates and discharge voltage needs to be set.
Operating Instructions
Function Button
INCREASE
DECREASE
ENTER
START
FLASH
Plug the charger into an AC 230V wall outlet or a DC 12V power source. The charger power is on now
and the LCD displays the MAIN MENU.
4 in 1 Digipeak Charger - #2141
Charge rate Charge time
0.6A 60 ~ 80 min.
1A 78 ~ 94 min.
2A 54 ~ 65 min.
5A 40 ~ 48 min.
Operation Signal
+
-
(enter)
S
' '
P. 3