BMI 4 in 1 Digipeak Bedienungsanleitung Seite 2

Thank you for purchasing the DIGI CHARGE AC/DC 4 in 1 5A Microprocessor Charger
& Discharger. The DIGI CHARGE is designed to charge and discharge 1-10 cell Ni-Cd,
Ni-MH battery packs, 1-4 cell Lithium Polymer battery packs and 2-6-12V Lead-Acid battery.
To ensure proper operation, read this instruction thoroughly before using this charger.
Incorrect operation may cause damage and danger. Always keep this manual at hand.
Warranty
We guarantee this product to be free of defects in materials and workmanship at the moment
of purchase. This guarantee doesn't cover any component or piece demolished into use,
modifi cations or deteriorations following from the applic-ation of adhesives or other products not
mentioned in the instructions. In no case our compensation will exceed the purchase value of the
product. We reserve the right to change or modify this guarantee without previous notice. As we have
no control on the fi nal assembly, no responsibility will be assured or assumed for any damage resulting
from the bad use of the product. By using this product the user assumes the total responsibility.
Safety precautions
• Please check the voltage in your house if it's consistent to this charger, you can only use
it when the voltages are the same.
• Do not allow children to charge battery packs unless supervised by a responsible adult.
• Use only rechargeable batteries. This charger can not charge primary batteries such as "Heavy duty",
"Alkaline battery" or "Mercury battery".
• During operation, keep the charger well ventilated and never place it next to infl ammables.
• This charger will be damaged if immersed in water or subjected to high level moisture.
Do not use this charger in the wet conditions in order to avoid electric shock or accident.
This is very dangerous to both the operator and the charger.
• There is fan built inside this charger, please do not try to obstruct this fan.
• The positive (red lead) and negative (black lead) terminals of the battery should be connected to the
charger terminals correctly. Do not reverse the positive and negative terminals,
wrong connection will damage the battery and will cause damage to the charger.
• Before you start to charge, please ensure you select correct charger settings.
Double check if the battery count and type match your charger setting. Make sure nothing goes wrong!
• The best current for charge/discharge is 1C (1 time of battery capacity).
Value of 1C = Cell capacity, e.g. if the battery capacity is 2000mA, 1C is 2000mA)
• Never discharge Ni-Cd and Ni-MH batteries below 0.8 volt per cell to protect service life
of the batteries. (For example, a 6-cell pack should not be discharged lower than 4.8 volts)
• If your charger has any error, send it back with the original box. Do not attempt to disassemble or
modify the charger in any way.
Features
• Computerised high-performance automatic 4 in 1 AC/DC charger;
• Suited for NiCd, NiMH, LiPo and lead-acid batteries
• Controlled by a 16 bits CPU microprocessor
• Charge current for NiCd and NiMH from 0,3A to 5 A
• Discharge current up to 2 A
• 2-line LCD screen displays all relevant parameters
(capacity, battery voltage, charge current, charge time)
• Delta-Peak cut-off detector with user-changeable sensitivity for NiCd and NiMH packs
• Charger can also be used for single cell glowplug batteries
• Protected against short-circuit and reverse polarity
• Turbo fan equipped for optimal cooling
4 in 1 Digipeak Charger - #2141 P. 2