Vitek Gentleman VT-1376 BK Betriebsanweisung Seite 6

ENGLISH
- Position the shaver at the correct
angle to the skin and move it gradu-
ally down, evening the whiskers.
- Turn off the shaver and move the
trimmer switch to the lower posi-
tion.
Cleaning the shaver
- Press the shaving block locking but-
ton (5) to open the shaving block
and gain access for cleaning (Pic.
4).
- Using the brush (10), clean the
shaving block inside and out, and
also the blade drive (Pic. 5).
- The shaving block can be washed
under a stream of warm water (Pic.
6). Dry the shaving block com-
pletely before closing. Do not allow
water into the electric shaver's
body. After completely dry, close
the shaving block, reinstall the pro-
tective cap (1) and put away for
storage.
It is recommended to clean the
shaving heads once every two
months (Pic. 7, 8)
- Turn off the electric shaver.
- Press the locking button (5).
- Pull up on and remove the shaving
block (Pic. 4).
- Turn the ring counter-clockwise
and remove the locking frame.
- Remove and clean the shaving
heads (separately rotating and non-
moving blades). Do not confuse the
rotating and non-moving blades.
This is important because the rotat-
ing and non-moving blades of each
head adjust to one-another, which
1376.indd 6 1376.indd 6
guarantees the optimal operat-
ing characteristics of each pair of
blades.
If you accidentally confuse a blade
block, it may take several weeks to
restore optimal shaving character-
istics.
- Clean the rotating blade with the
brush. Use the side of the brush
with the short bristles.
- Clean the non-moving blades with
the brush.
- Replace the shaving heads onto
the shaving block, install the lock-
ing frame and turn the ring clock-
wise.
- Turn the non-moving blades clock-
wise/counter-clockwise to lock
their plastic frame.
- Re-install the shaving block onto
the shaver.
Trimmer
- Clean the trimmer after each use.
- Turn off the electric shaver.
- Clean the trimmer using the brush
(10) included in the package.
- Apply drops of sewing machine or
hair clipper oil to the trimmer every
six months.
Replacing the shaving heads
(Pic. 7, 8)
To achieve optimal results from your
shaver, replace the shaving blocks
every 2 years.
- Turn off the electric shaver.
- Press the locking button (5) and
remove the shaving block (Pic. 4).
- Turn the ring counter-clockwise
and remove the locking frame.
6
28.02.2006 10:36:09 28.02.2006 10:36:09