Location And Function Of Parts - Sony IFB-12A Bedienungsanleitung

The IFB-12A signal interface board is a PC board to be mounted on
the projector or the signal interface switcher, etc. so that RGB and
audio signals from a computer, etc. can be input or output
interface switcher.

Location and Function of Parts

12
R/P
R-Y/VIDEO
1 IN/OUT (input/output) selector
By setting the IN/OUT selector, the BNC connectors 3 function as
the input/output
2 Indicator (red)
Lights up when the IFB-12A is selected or the IN/OUT selector is
set to OUT.
3 Input/Output connector (BNC type)
When the IN/OUT selector is set to IN
Accepts RGB, component, HDTV
When the IN/OUT selector is set to OUT (Refer to the manual of
the equipment to be connected also.)
Output RGB, component and HDTV signals.
4 AUDIO (L(MONO)/R) connectors (phono jack)
When the IN/OUT selector is set to IN
Connect to the AUDIO OUT connector on a VTR, etc. When
connecting a monaural audio source, connect it to L (MONO).
When the IN/OUT selector is set to OUT
Connect to the AUDIO IN connector of a monitor, etc.
1)
Refer to the attached paper about the products on which the IFB-12A can be
mounted.
2)
HDTV: 1125/60 interlaced HDTV Studio Standard.
10
3
G/Y B/P SYNC/HD
R
B
Y/Y B-Y/C
IN OUT
1)
connectors.
4
VD
L
R
ON
1 2 3 4 5 6
AUDIO
2)
, S-VIDEO, VIDEO signals.
1)
IFB-12A.3-858-497-04 (1)
1)
to a signal
5
(MONO)
1)
1)