Cognex In-Sight 7000 Gen2 series Handbuch Seite 13

1. Remove the rubber faceplate covering the image sensor window, if
present.
2. Remove the protective film covering the threaded lens opening, if present.
3. Place the adapter on the faceplate of the vision system. Insert the four
adapter screws and tighten; the maximum torque is 0.90 Nm (8 in-lb).
4. Thread the lens into the vision system.
5. (Optional) For longer lenses, the C-Mount cover extender accessory (COV-
7000-CMNT-LGX) can be used to add 30mm in length to the C-Mount
cover. If using the cover extender, attach it to the vision system and rotate
the cover extender clockwise approximately thirteen degrees to lock it.
6. Attach the cover to the vision system. Rotate the cover clockwise
approximately thirteen degrees to lock it.
12