gc GRADIA PLUS Bedienungsanleitung Seite 8

NOTES
• Please review this Instruction for Use carefully before using the product. After reviewing the Instructions for Use, keep them
in a convenient place for quick reference if necessary. If this Instruction for use is lost, contact the distributor or supplier
shown on the package.
• This product must only be used by dentists or dental technicians.
• To prevent troubles with operating or storing, the product should be used according to the instructions specified in this
Instruction for Use. Do not use this product for contraindications given in this Instruction for Use.
• Assure that the crown or inlay is sufficiently thick, using the methods for preparing abutments and cavities described in this
manual.
• Wear gloves or take other appropriate measures when using the product.
• After dispensing, use immediately and replace caps on syringe or bottle.
• Avoid separation of the coating (Lustre Paint) from the orthoprosthesis. Sandblast the surface of orthoprosthesis with
alumina particles, 50 m diameter before applying the connector.
• Avoid desorption of the orthoprosthesis. Use a dental adhesive resin cement to lute jacket crowns, veneers, inlays or onlays.
Sandblast the inner surface of the jacket crowns, veneers, inlays or onlays using low pressure (1.5 kg/cm
• The oxygen inhibited layer of the resin surface to be coated should be removed before applying Lustre Paint as it may hinder
the proper curing of Lustre Paint.
• For curing Lustre Paint, violet LED (effective wave length: 390-430nm) is required.
• Place the light source as close as possible to the resin surface. Set a 2cm platform in the curing device and place the
prosthesis on it with the coated surface facing the light. Reverse the prosthesis and repeat the light curing to fully cure the
undercut or area in shadow.
CAUTION
1. In rare cases, this product may cause sensitivity in some people. If such reactions are experienced, discontinue the use of the
product and consult a physician.
2. Wear eye protection and plastic or rubber gloves during operation in particular to avoid direct contact with paste and air
inhibited resin layers in order to prevent possible sensitivity.
3. LUSTRE PAINT DILUTING LIQUID, SEPARATOR, DIE HARDNER, GC METAL PRIMER II / GC METAL PRIMER Z and
GC CERAMIC PRIMER II are highly flammable liquid and vapour. Do not use near naked flame. Keep away from sources of
ignition. Keep away from direct sunlight.
4. When adjusting or polishing the veneer surface, use a dust collector and wear a dust mask to avoid inhaling dust.
5. In case of contact with oral tissues or skin, immediately remove with cotton. Flush with water.
6. In case of contact with eyes, immediately wash the eye with copious amounts of water and seek medical attention.
7. This product should not be used for malocclusion, clenching or bruxism.
8. At the time of cementation, sandblast the inner surface of metal free restorations, and then be sure to treat the inner surface
with a silane coupling agent (e.g. CERAMIC PRIMER II (GC)).
9. Dispose all waste according to local regulation.
10. To prevent cross contamination between patients, do not reuse the dispensing tip.
11. The dispensing tip cannot be sterilized in an autoclave or chemiclave.
12. Wear protective eye glasses during light curing.
13. Lower light intensity may cause insufficient curing.
STORAGE
Recommended for optimal performance, store in a cool place (4-25°C / 39.2-77.0 °F) away from high temperatures or direct sunlight.
Shelf life: 3 years from the date of manufacture.
Some products referenced in the present IFU may be classified as hazardous according to GHS.
Always familiarize yourself with the safety data sheets available at:
http://www.gceurope.com
They can also be obtained from your supplier.
Last Revised: 06/2016
).
2