Lentz HHB1795 Bedienungsanleitung Seite 14

CAUTION!
PROPERTY DAMAGE!
• The electric kettle becomes very
hot after operating it. Hold only the
handle of the kettle and operate
only the unlock key and the on/off
switch.
• In any case, do not fill alcohol,
sugar or milk in the electric kettle!
Implementing:
commissioning and boiling water
(100°C):
1. Place the appliance on a dry, flat,
skid resistant base.
2. Pick the electric kettle (1) from the
appliance base (2) and open the lid
(3) of the electric kettle (1).
3. Fill the kettle (1) until the marking,
that shows the maximum fill level and
close back the lid (3) opened earlier.
4. Place the electric kettle (1) again
on the appliance base (2).
5. Insert the mains plug in a well
accessible electrical socket, the
voltage of which complies with the
data on the type plate.
6. The kettle beeps once to confirm
the readiness for operation and the
LED light of the kettle flashes thrice.
Thereafter, an LED blinks in the
On-Off-Switch (4) signaling that the
kettle is in the ready for operation
mode.
7. Now heat the water where the
Water On-Off-Switch (4) is briefly acti-
vated. This is confirmed with a beep.
The On-Off-Switch (4) of the kettle
and the LED light now keep flashing
continuously during the cooking
process. After the water is heated,
14 - EN
74134 Bedienungsanleitung.indd 14
the device switches on, and the LED
light switches off automatically and
the device beeps twice.
8. Pour out the water and rinse the
interior of the electric kettle with
fresh water.
9. Once you have repeated this
process, the appliance is ready for
use.
Temperature selection
(60, 70, 80, 90°C):
To select the water temperature
proceed as follows.
1. Note the aforementioned steps
1.-6.
2. Select the desired temperature by
activating the switch Temperature
Selection (5). The currently selected
temperature shows the device on
the keypad. Each input is confirmed
with a beep.
3. When the desired temperature
is set, start the cooking process by
briefly activating the On-Off Switch
(4).
4. The indicator light of the kettle
and the LED light now keep flashing
continuously during the cooking
process. After the water is heated,
the device switches on, the indicator
light and the LED light switches off
automatically and the device beeps
twice.
Warm keeping function
(60, 70, 80, 90, 100°C):
The warm keeping function can be
selected for all temperatures.
1. To activate the warm keeping
function, hold the On-Off-Switch (4)
pressed for 2 seconds.
15.03.19 17:19