Control Settings; Verifi Cation Procedure - Carrier 80AW9019 Beschreibung

Installation
If the kit to be connected is on the left, refer to the following table.
Component
Water pump
Water temperature sensor (TW)
Room temperature sensor for zone 2
3 Way valve actuator
Floor heating manual reset protection (TM)
If the kit to be connected is on the right, refer to the following table.
Component
Water pump
Water temperature sensor (TW)
Room temperature sensor for zone 2
3 Way valve actuator
Floor heating manual reset protection (TM)
Control setting
Use the user interface to set the control parameters
according to the type (3W or D) and position (zone 1 or
zone 2) of the kits that have been installed. The procedure is
explained in the hydronic module manual.

Verifi cation procedure

Component
Water pump
Water temperature sensor (TW)
Room temperature sensor for zone 2
3 Way valve actuator
(1) Valve rotation is slow; please wait some minutes
(2) After verifi cation release the button or rotate the lever back to its original position
128H72_GB.indd Sez1:9 128H72_GB.indd Sez1:9
WATER PUMP
Black cable 3W VALVE CLOSE
Brown cable 3W VALVE OPEN
Blu cable Between black and brown
Remove the factory fi tted
WATER PUMP
Black cable 3W VALVE OPEN
Brown cable 3W VALVE CLOSE
Blu cable Between black and brown
Remove the factory fi tted
Turn on the system and
verify that pump is rotating
Check TW1 value on the
user interface
Select OFF on the user
Valve closing interface and verify that the
valve closes (1)
Press or rotate the lever on
Valve opening the 1K relay and verify that
the valve opens (1) (2)
TERMINAL BLOCK NAME
ZONE 1 ZONE 2
WATER PUMP
TW1
- SENSOR AMB 2
3W VALVE OPEN
3W VALVE CLOSE
Between black and brown
TM1
Remove the factory fi tted
shunt
TERMINAL BLOCK NAME
ZONE 1 ZONE 2
WATER PUMP
TW1
- SENSOR AMB 2
3W VALVE CLOSE
3W VALVE OPEN
Between black and brown
TM1
Remove the factory fi tted
shunt
TERMINAL BLOCK NAME
ZONE 1
Turn on the system and
verify that pump is rotating
Check TW2 value on the
user interface
Check the room
- temperature in zone 2 on
the user interface
Select OFF on the user
interface and verify that the
valve closes (1)
Press or rotate the lever on
the 2K relay and verify that
the valve opens (1) (2)
3W
TW2
TM2
shunt
3W
TW2
TM2
shunt
3W
ZONE 2
80AW9019 - 9020
1-01-1970 3:01:55 1-01-1970 3:01:55
D
D
D
9