General Description; Connection Of The Bus Cable To The Knx/Eib Clamp; Connection Of The Transponder Reader To The Bus Line; Configuration - Gewiss GW 10 681 Bedienungsanleitung

To start up the device you must access the "KNX / EIB Button" to switch from normal mode
to programming mode; the button is on the back of the casing.
When installing the device, make sure that the connection cables are long enough to extract
the device / support frame from the flush-mounted box together.

Connection of the bus cable to the KNX/EIB clamp

The Bus KNX / EIB clamp (supplied with the device) is suitable for a single wire
conductor with a Ø 0.6-0.8 mm.

Connection of the transponder reader to the bus line

Insert the KNX / EIB Bus clamp, previously connected to the bus cable, into the
integrated bus coupling slot which is on the back of the device. Slide the bus clamp as
far as possible.
The transponder reader must be configured using one of the access management
softwares - "GWHotel" or "GWAccess" used to configure the transponder cards and the
assigning of access rights
INSTALLATION

General description

Configuration

21
E
N
G
L
I
S
H