Vitek VT-1378 BK Betriebsanweisung Seite 6

- Position the shaver at the correct
- Turn off the shaver and move the
cleaning the shaver
- Press the shaving block locking but-
- Using the brush (10), clean the
- The shaving block can be washed
it is recommended to clean the
shaving heads once every two
months (pic. 7, 8)
- Turn off the electric shaver.
- Press the locking button (5).
- Pull up on and remove the shaving
- Turn the ring counter-clockwise and
- Remove and clean the shaving heads
If you accidentally confuse a blade
1378.indd 6
engliSh
angle to the skin and move it gradu-
ally down, evening the whiskers.
trimmer switch to the lower position.
ton (5) to open the shaving block and
gain access for cleaning (Pic. 4).
shaving block inside and out, and
also the blade drive (Pic. 5).
under a stream of warm water (Pic.
6). Dry the shaving block complete-
ly before closing. Do not allow water
into the electric shaver's body. After
completely dry, close the shaving
block, reinstall the protective cap
(1) and put away for storage.
block (Pic. 4).
remove the locking frame.
(separately rotating and non-moving
blades). Do not confuse the rotat-
ing and non-moving blades. This is
important because the rotating and
non-moving blades of each head
adjust to one-another, which guaran-
tees the optimal operating character-
istics of each pair of blades.
block, it may take several weeks to
restore optimal shaving characteris-
tics.
- Clean the rotating blade with the
brush. Use the side of the brush
with the short bristles.
- Clean the non-moving blades with
the brush.
- Replace the shaving heads onto
the shaving block, install the lock-
ing frame and turn the ring clock-
wise.
- Turn the non-moving blades clock-
wise/counter-clockwise to lock
their plastic frame.
- Re-install the shaving block onto
the shaver.
trimmer
- Clean the trimmer after each use.
- Turn off the electric shaver.
- Clean the trimmer using the brush
(10) included in the package.
- Apply drops of sewing machine or
hair clipper oil to the trimmer every
six months.
replacing the shaving heads
(pic. 7, 8)
To achieve optimal results from your
shaver, replace the shaving blocks every
2 years.
- Turn off the electric shaver.
- Press the locking button (5) and
remove the shaving block (Pic. 4).
- Turn the ring counter-clockwise and
remove the locking frame.
- Replace the shaving heads, install
the locking frame and turn the ring
clockwise.
- Turn the non-moving blades clock-
wise/counter-clockwise to lock
their plastic frame.
6
29.11.2013 14:53:10