Led Replacement; Replacing The Protective Disc - Ecom Lite-Ex PL 10e Bedienungsanleitung

When it has been cleaned replace the ring
switch and rotate it until it engages firmly in
place (magnet must be positioned on the shaft -
ecom address side). The lamp head can then be
screwed back onto the flashlight.

8.5 LED replacement

The Lite-Ex PL 10e is equipped with a long-
life LED bulb. Under normal conditions it is
not necessary to change the LED. If, however,
the torch is defective or the brightness of the
torch has diminished, it should be sent to ecom
instruments for inspection or repair. The LED
housing should not be opened!
Manipulating the torch head or LED on your own
poses a risk to the safety of the flashlight and is
not permitted.

8.6 Replacing the protective disc

The LED housing is protected by the surrounding
housing head and an additional protective disc,
which is located over the opening where the
beam is emitted. The disc is made of high-quality
material. Should, however, the disc break, it is
possible to replace it. To do this grasp the body of
the Lite-Ex PL 10e and the ring switch and then
carefully unscrew the lamp head by turning it
anti-clockwise. To unscrew the lamp head from
the LED housing use an Allen key (AF4) to secure
the LED housing in place (see Fig. 2) and unscrew
the lamp head. The protective disc can now be
replaced (only use original ecom protective
disc). The LED housing should then be cleaned
thoroughly (Please observe point 11) and the
sealing ring checked for signs of damage. If the
sealing ring exhibits any damage, it should also
be replaced (the sealing ring is set in a groove
under the protective disc). When replacing the
10