Important Notes - COMO AUDIO Amica Kurzanleitung

Your guide to Amica
EN
1. Fully insert the red male RCA connector on Amica's audio cable into the female RCA output
on the back of Amico.
2. Place the switch on the back of Amico in the "ST" (stereo) position. Be careful not to place
the switch in the "L" or "R" position. We recommend leaving the Balance in the center
position, but if necessary, you can adjust it in Amico's System Settings Menu under
"Equalizer".
3. The further away you place the Amica from Amico, the wider the stereo soundstage will
be. For accurate reproduction, when facing the units, Amico should be on the left side and
Amica on the right since all right channel audio will be sent to the Amica.

Important notes:

Do not use Amica for any purpose other than the dedicated right channel for Amico.
Do not obstruct Amica's rear bass port. Placing Amica in a bookshelf or corner will exaggerate
the bass.
Wood is a product of nature, and as such, has characteristics that can vary greatly. Although
every effort has been made to reasonably match your Amica to your Amico, differences should
be expected. It is precisely these naturally occurring variations that provide the uniqueness of
each wood cabinet.