How To Level Your Refrigerator - Amana xrs s 264 bb bw Handbuch

Installing Your Refrigerator
How to Install the Handles
Stainless Steel Handles continued
5
Insert screw plug into predrilled
hole.
6
Repeat steps 2 through 5 to install
freezer handle.
How to Connect the Water Supply
• Contact a qualified engineer to perform this task.

How to Level Your Refrigerator

• To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.
• To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.
• DO NOT adjust unit to be any shorter than 173.9 cm tall (minus hinge and cap). Doing so may damage underside
components.
Materials Needed
• 3 / " hex head driver
8
1
Remove Toe Grille and
Bottom Hinge Covers
• Open both doors 180°, or as wide as
possible, to remove.
2
Turn both front adjustment
screws (A) clockwise to raise
and counterclockwise to
lower.
What if my doors are not aligned?
• Locate the higher door, and turn front adjustment screw
counterclockwise. Continue until doors are level.
• If bottom of adjustment range is reached, and doors are
not level–raise opposite door by turning front
adjustment screw clockwise.
• Replace toe grille
continued
!
• Level
A
To remove after initial install...
• Follow steps 2 through 5 in reverse order.
IMPORTANT: To avoid damage to unit, use
a flat blade screwdriver edge wrapped in
masking tape to remove screw plugs.
CAUTION
3
Turn both rear adjustment
screws (B) clockwise to raise
and counterclockwise to
lower.
4
Check with level to verify 6 mm tilt to the
back for proper door closure.
• If unit is aligned and stable, replace toe grille.
What if my unit rocks?
• Turn rear adjustment screw clockwise to raise
rocking corner.
• Replace toe grille.
6
B