Getting Started - Ribimex Ribitech PRBAT20/P Bedienungs- Und Wartungsanleitung

The operator and/or user must use common sense and caution when operating the product especially for any
matters that are not referred in the above
12. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual, may
present a risk of injury to persons or animals and may cause damages.
13. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts, otherwise it may result in
considerable danger to the user.
ATTENTION! The machine's operation generates a certain level of noise. National or local regulations may
restrict the use of the machine to certain hours. Check with your local authority.
IV. GETTING STARTED
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage.
4.2- Assembly
The tool does not require assembly prior to first time use.
4.3- Battery
Note: The battery is supplied partially charged. To ensure proper running of the tool, completely charge the
battery in the provided charger before first time use.
Tips to ensure optimal battery life
- Do not to drop, hit, or damage the battery.
- Recharge the battery before it is completely drained.
When you notice that the tool performance is decreasing, recharge the battery accordingly.
- Never charge a fully charged battery. Overloading reduces its life.
- If the battery is hot, allow it to cool down before proceeding with charging.
- When the product is not used, it is recommended to charge the battery every 3 months.
Inserting and removing the battery (Fig.2)
a) To insert the battery: slide the battery into the handle's compartment.
Make sure that the battery is securely locked.
b) To remove the battery: press the release button (6) and pull battery out of its compartment.
Charging the battery (Fig.3)
- Place charger on a flat and dry surface within 1m of a wall socket.
- Remove battery from tool
- Fig.3: Insert battery (5) into charger (11).
- Plug in battery charger to wall socket (power source)
(Only use with provided adaptor)
- Charge battery 20V 2.0Ah for 1 hour and battery 20V 4.0Ah for 2 hours.
- After charging, remove battery from charger and insert it on tool.
- Then disconnect charger from mains and store it adequately.
Note: Maintain the charger and the battery at a temperature between +10°C and +40°C.
4.4- Switch On/Off (Fig.1)
To operate product, press on trigger switch (7).
To stop product, release the trigger switch (7).
Note: the switch cannot be activated wen the selector (8) is set in middle position.
Page 20 / 62