Tips For Cutting - ims PRO 30FV Betriebsanleitung

TIPS FOR CUTTING

• Lightly drag the tip on the part for an even cut. This will guarantee a constant, adapted distance.
• When cutting, ensure that the sparks come from the bottom of the part . The sparks should lag slightly behind the torch when cutting (angle of
15 ° to 30 ° from the vertical).
• If the sparks fly from the top of the part, slow the movement, or set the output current to a higher level.
• For straight cuts, use a ruler as a guide.
MANUAL CUT FROM THE EDGE OF THE PART
With the earth clamp is fastened to the part, maintain the torch's tip perpendicu-
1
larly (90°) to the edge of the part.
Press the torch's trigger to start the arc until this one has completely cut into the
2
part.
Once the part is cut, slightly drag the tip on the part to continue the cut. Try to
3
maintain a regular rythmn.
PART PIERCING / CUT IN THE MIDDLE OF THE PART
With the earth clamp is fastened to the part, maintain the torche at an angle of
1
roughly 30° to the part.
Press the torch's trigger to start the arc while maintaining an angle of 30° to the
2 part. Slowly rotate the torch
towards a perpendicular position (90°).
Immobilise the torch while keeping the trigger pressed. If the sparks come from
3
below the part, the arc has cut the material.
4 Once the part is cut, slightly drag the tip on the part to continue the cut. Try to maintain a regular rythmn.
PLASMA CUTTER 30 FV
EN
17