Velocity Storage - phynix DC-2000C Bedienungsanleitung

 press
 press
 press
 press
 press
 press
thickness value,
 press
Smaller numerical values can be obtained by pressing this key several
times.
 Repeat the last two steps until the displayed thickness value
corresponds to the actual thickness value d
 Press
velocity.
 press
 press
 press
This new velocity will be stored in one of the four locations. It can be selected
at menu 2. Velocity rate - 4. Vel.storage.
Alternatively, the speed of sound can also be calculated:
V
unknown

17.4.2.4. Velocity Storage

DC-2000 series provides 4 locations to store new velocities. Select one of these
as follows:
into 1. Measurement ,
or to select 2. Velocity rate,
to confirm ,
or to select 3. Vel. measurement,
to confirm ,
to move the cursor ▼ to the required digit position of the
to increase the numerical value at that position by 1.
to confirm. The display shows 4 locations to store this new
or to select one location,
to confirm.
to get back to measurement.
= (v x d
measurement
) / d
workpiece display
.
workpiece
.
31