Connecting The Ir Module; Frequently Asked Questions (Faqs) - vogel's SAVA 1014 Gebrauchsanleitung

5.4

Connecting the IR Module

POWER
1 Connect the installed IR Extender cables with blaster LEDs)
to the 'IR OUT' connection on the IR Module.
Connect the installed IR Receiver cable to the 'IR IN'
2
connection on the IR Module:
Connect the USB Power adapter to the 'POWER' connection
3
on the IR Module and plug this into an electrical socket.
If the SAVA 1014™ is correctly connected, the 'IR data' light
4
will blink on the IR Module if you press a button on the
(infrared) remote control while pointing towards the IR
receiver.
5 Close the doors of your cabinet to ensure that the A/V
equipment cannot receive an infrared command directly from
the remote control as this can lead to operational problems.
6 You can now operate the A/V equipment via the
SAVA 1014™ through closed cupboard doors!
6

Frequently asked questions (FAQs)

The A/V equipment does not respond to signals from my
remote control.
Take the following instructions into account:
•
The IR receiver has a receiving sensitivity of about 10 metres
with an acceptance angle of 60 degrees. Range is also
dependent on the remote control used.
•
If the 'IR data' light on the IR Module is continuously
illuminated, the IR receiver is probably being disrupted by
another infrared signal. Try to locate the IR receiver so that it
encounters as little disruption as possible from, for example,
SAVA 1014
IR OUT IR IN
9