How Does It Work; Installation - vogel's SAVA 1014 Gebrauchsanleitung

4

How does it work?

Locate your A/V device in a closed cabinet or TV unit. The IR
receiver (1) must be located in view of your remote control. Stick
the IR blaster LEDs (2) wherever you like in the cabinet or TV unit.
You will then be able to operate all of the A/V devices in that
specific section. You can then place the IR modules (3) in discrete
locations. Point the remote control towards the small IR receiver in
order to send the desired command (via the IR module) to the IR
blaster LEDs; these will then send on this infrared command to the
A/V equipment.
5

Installation

In order to check that the system works correctly, it is advisable to
first test the set-up you had in mind. To do so, connect everything
as described below but do not stick the components securely.
6
© VOGEL'S