Troubleshooting - Wisenet BabyView Eco Flex SEB-102CRW Bedienungsanleitung

CAUTION: If you are using this system to watch a young child, please do not place the camera within the
child's reach.
Before you install the camera, carefully plan where and how it will be positioned, and where you will route
the cable that connects the camera to the power adapter.
Before starting permanent installation, verify its performance by observing the image on the monitor when
camera is positioned in the same location/position where it will be permanently installed and the monitor is
placed in the location where it will be used most of the time.
Installation Warnings
Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a clear
view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong light
source or direct sunlight.
Avoid installing the camera where there are thick walls or obstructions between the camera and the monitor.
STRANGULATION HAZARD - Keep cord out of child's reach. NEVER place camera or cords within 3 feet of
crib or playpen. Never use extension cords with AC Adapters. Only use the AC Adapters provided.
Trouble Shooting
Problem
No picture from a
camera
The picture is or has
become choppy
No sounds (even
with both units
turned on)
Your BabyView Eco
FLEX is emitting an
high pitched noise/
feedback.
Monitor screen is
frozen.
Low battery will cause the supply current to become unstable and will affect the quality of the video/audio.
n
`
Please charge the battery fully for superior video.
English · 8
1. Check all connections to the camera. Make sure the adapter is plugged in.
2. Make sure that the cameras and monitor are both ON.
3. Make sure that the camera is in range of the monitor.
4. Make sure the camera and monitor are paired.
5. Adjust the monitor antenna to a vertical position.
The picture may become choppy when experiencing a lower frame rate
(i.e. 10 frames per second vs. a higher 20 frames per second).
1. Try moving the camera closer to the monitor.
2. Remove obstructions between the monitor and camera.
3. Adjust the monitor antenna to a vertical position.
1. Make sure that the power adapter is connected to the camera.
2. The battery on the monitor may be dead, be sure to charge it using the adapter included.
3. The monitor may be out of range from the camera.
This sound is normal feedback which occurs if the monitor and camera are too close together.
Move the units apart and the monitor will not emit high pitched noise/feedback.
Restart your monitor and check the connection to the camera. If the baby monitor displays the
"Out of Range" message, move the monitor closer to the camera.
Solution