Control Panel; Display Window; Operation - Cosmo DC16ET Bedienungsanleitung

CONTROL PANEL

1. Heat button (only for the model with heat func
tion)
2. UV light (only for the model with UV function)
3. Timer

4. Display window

5. Speed (ventilation) button
6. Humidity selection button
7. ON/OFF button
DISPLAY WINDOW
1. Humidity display:
50%, 60%, 70%, 80%
2. Ambient humidity condition:
good, fair,
means 50% < ambient room humidity < 70%
means 30% < ambient room humidity < 50%
or 70% < ambient room humidity < 80%
means the ambient room humidity is higher
than 80%.
3. compressor is in progress. In case the de-
frost function is working, the water drops will
flash.
compressor is not in progress.
water full.
4. Heat indicator (only for the model with heat func-
tion): While you press the heat button and the
ambient temperature is lower than 25°C, the heat
indicator will light on and the heater will work. At
this time, the fan speed will keep at high speed
only. However, if the ambient temperature is
higher than 25°C, the heat indicator will not light
on and the heater will not work, either.
* This PTC heater is protected by thermostat & thermal fuse
for overheat protection.
continuous de-humidifying,
bad
5. UV ( ultraviolet ) indicator.
* UV can kill the bacteria in the air.
6. Timer indicator, 1 to 24 hours.
7. Room temperature indicator, can display the room
temperature in Celsius degree ( °C) by pressing
"HUM" button at least 2 seconds.
8. Fan speed/ventilation indicator:
low speed.

7. OPERATION

high speed,
17