Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Positioning of back stirrup
- Fix the fastening position of the back stirrup by respecting the
"A"
dimensions
- Fasten the stirrup through fitted screw anchors (if the pillar is a
masonry) or welding it (if the pillar is iron made).
- Check the stirrup is lined up and parallel to the ground.
Positioning of front stirrup
- Carry the gate wing to the position of total closing, fixed by the
mechanical stop block.
- Fasten the stirrup through fitted screws to the gate frame
respecting the dimension
- Check the stirrup is lined up and parallel to the ground.
Manual unblocking
The manual unblocking causes the release of the actuator from the
wing, allowing the manual displacement of this one. It can be used in
case of electric voltage lack or of installation failure. The unblocking
is made through a hexagonal key that is to be kept by user in a sure
and easily reachable place. .
"B"
and
reported on the assembling table.
"C"
reported on the assembling table.
- 12 -
by
Werbung
Inhaltsverzeichnis
