Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before fastening the stirrups check the dimension
more than the value reported in the assembling table. In the following assembling
table are reported the reference dimensions for the set up of the actuator.
OPENING
90°
120°
K1
IMPORTANT: it is obligatory that two stop stirrups are installed to establish the
opening limit (K1) and the closure limit (K2) of the wing. It is also essential that the
fixing point on the wing (X) doesn't correspond to the complete run of the stem
(
extracted
piston totally), but that the stem is retracted at least 1 cm. Moreover, in
the position K1, It is essential that the stem of the piston is not retracted totally, but
that It come out at least 1 cm.
s
WARNING:
it is advisable not to choose values of
between them, so to ensure a regular move of the wing and a lower stress on the
actuator. By increasing the dimension
therefore, the thrust on the wing is reduced and the peripheral speed increased.
By increasing the dimension
thrust on the wing is increased and the peripheral speed reduced.
A (mm)
190
167
"A"
the opening corner grows up and,
"B"
the opening corner is reduced and, therefore, the
- 11 -
"C"
on the support frame is not
B (mm)
190
155
K2
"A"
"B"
and
too different
ENGLISH
C (mm)
1160
1160
K2
X
Werbung
Inhaltsverzeichnis
