Technical Data; Brief Description - Felisatti H10,5/1200EV Bedienungsanleitung

Demolition Hammer
Rated voltage
Rated current
Rated frequency
Rated power
Impact rate
Nominal impact energy
Chisel positions
Anti-vibration handle
Weight according to EPTA-Procedure 01/2003
Protection class
Tool holder
Acoustic pressure, Lpa
Sound power level, Lwa
Error, К
Vibration acceleration
Error, К
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
In accordance with essential applicable safety
standards of Russian Federation
Wear eye, ear, breathing protection
Follow very carefully the instructions in this manual,
save it and keep it close at hand, ready to carry out any
inspection of parts that may be necessary.
If the tool is used with care and normal maintenance is
carried out, it will work well for a long time.
The functions and use of the tool you have bought
shall be only those described in this manual. Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Dust protection cap
2 Locking sleeve
3 Chisel adjustment ring
4 Auxiliary handle
5 Damper
6 On/Off switch

TECHNICAL DATA

V~
А
Hz
W
bpm
J
number of positions
-
kg
dB(A)
dB(A)
dB(A)
m/s
2
m/s
2
7 Principal hand grip
8 Thumbwheel for preselection of impact rate
9 Service indicator
10 Knurled nut for auxiliary handle
11 Indicator of power (Mod. H10,5/1200EV)
12 Cap
- Auxiliary handle
- Tube of grease
- Operating instructions with Safety instructions
- Warranty
The machine is intended for chiselling work in concrete,
brick, masonry and asphalt as well as for driving in and
compacting, when using the respective accessories.
BEFORE USING THIS TOOL
WARNING! Before carrying out any work, check, for
instance, using a metal detector, that there are no electric wires
or gas or water pipes under the surfaces you wish to work on.
Make sure the mains voltage is correct: it must be
the same as that on the specification label. Machines with
230V can also be connected to a 220-V mains supply.
For mod. H10,5/1200EV. When connected to power
source, indicator of power is lighted.
WARNING! Always disconnect the plug from the
socket before doing any work on the machine.
1. Auxiliary Handle
Operate your machine only with the auxiliary handle
4. The auxiliary handle 4 can be set to any position for a
secure and low-fatigue working posture. Loosen the knurled
nut 10, rotate the auxiliary handle 4 around the axis of the
Н18/1500EV H10,5/1200EV
230
6.8
50
1500
1000... 1900 2700...3700
18
12
Yes
10.7
ll
SDS Max
89
100
3
16
1.5
EQUIPMENT

BRIEF DESCRIPTION

5.5
1200
10,5
6.4
87
98
2.4
15
1.5
5