Operation-Cd Player; Specifications - Rockford Fosgate RFX series Einbau Und Betrieb

O – CD P
PERATION
Magazine Eject
1. Slide door open in the direction shown.
2. Press the EJECT button to release the disc
magazine from the CD changer.
NOTE: If the front eject button does not work, a
manual eject lever is visible through a hole
at the bottom of the unit. Move the lever in
the direction shown to eject magazine.
Loading Disc to the Magazine
1. Pull out the desired disc tray number from the
magazine.
2. Place the disc into the magazine, label side up.
3. Push the disc tray back into the magazine.
NOTE: Discs numbers are arranged from the bottom
up.
Loading the Magazine to the CD Changer
The INSERT IN THIS DIRECTION arrow indicates
the proper direction that the magazine should be
loaded into the CD changer.
CAUTION: Avoid installing or leaving
!
the magazine where it would
be subject to high
temperatures such as from
direct sunlight or from hot air
from the heater. Doing so will damage the unit.
S
PECIFICATIONS
General
Operating Voltage
Compatible Discs
Frequency Response
Signal-to-Noise Ratio
Channel Separation
T.H.D.
Output Power
Overall Dimensions
Weight (Mass)
Specifications subject to change without notice
8
LAYER
Eject
Model RFX8620M
13.8V DC
5" (12cm)
20-20kHz
90dB
70dB
0.03dB
700 mV
Height: 2-1/2" (63mm)
Width: 10" (254mm)
Depth: 6-3/16" (157mm)
3.13lbs (1.9kg)
Slide Door
Manual Eject
Label
Side Up