Additional Error Messages; Specifications - Sony LKRI-004 Bedienungsanleitung

When you connect a computer to the DVI-D connector or the AUX
connector, set the desired EDID ROM. EDID ROM to be used vary
depending on the input signal type.
For details, refer to "Setting the DIP Switch (S101)" (page 21).
For both the Switch 1 and Switch 2, the same setting is required.

Additional Error Messages

When you mount the board into an SR projector, the following error
message will be added.
For details on error messages, refer to the Operating Instructions of your SR
projector.
No. Error message
1 DVI SIGNAL FAILURE

Specifications

Input
Quantization
Dimensions (w/h/d)
Mass
Supplied accessory
Switch 1
ON
OFF
Meaning
An inappropriate menu setting or input signal is
found, or the cable is disconnected or down.
Switch 2
ON
OFF
DVI 24-pin, male (2)
DVI-D, AUX:
DVI1.0 (When 8 bits are set)
8 bits (DVI1.0)
10 bits (Sony unique specification. When the
Single mode or Twin mode is set)
168 × 26 × 200 mm (6
Approx. 300 g (11 oz)
Operating Instructions (1)
EDID ROM used
ROM 1
ROM 2
5 × 1 1 × 7 7
/ / / inches)
8 16 8
Operation 19