Agrilight AGRIBOX pro Schnellstartanleitung Seite 11

Calibrate light sensor
The light level is controlled with a light sensor which must be placed on the north side of the
barn. The light outside of the barn could influence the light level inside the barn. Therefore a
calibration has to be made. For all settings, read the complete manual of the AGRIBOX pro.
Daylight compensation
If you have connected a light sensor, we advise to set Daylight Compensation to ON. When
setting Daylight Compensation to ON, the system will use the light sensor value to decide
when to turn on the lights (dimmed or full). During dusk, dawn or very dark cloudy days the
light level inside the barn is "lifted up" (by dimmed light) till the advised level. You can link
daylight compensation to a group by means of a program.
This option can be found under Settings. This has to be activated separately for
each group.
Set the light sensor dip switches in the 20 kLux position before calibration:
Dipswitch 3 ON, Dipswitches 1,2 and 4 OFF. Set the light sensor dip switches in the 2 kLux
position after calibration: Dipswitch 2 ON, Dipswitches 1,3 and 4 OFF.
Screen compensation
If the building is fitted with screens, you can set screen compensation for each group.
This option can be found under Settings. This has to be activated separately for
each group.
Step 4 Using the AGRIBOX pro
Once you have set the AGRIBOX pro, you can change settings at any time. You can modify
programs. You can add or remove fixtures, etc. It is also possible to operate the groups
manually.
11