Agrilight AGRIBOX pro Schnellstartanleitung Seite 10

Divide the fixtures into groups
You have created groups and the fixtures have been found. You can now assign the fixtures to
the groups. This has to be done individually for each fixture, so this may take some time. Have
you divided all the fixtures into groups? Then you are ready to set lighting programs.
Press and go to Settings > Assign.
Set lighting programs
A lighting program allows you to switch the fixtures on and off within a period of 24 hours at the
times desired by you. A total of 10 lighting programs can be set. 8 times can be set per lighting
program.
and go to Program
Press
Example:
From 6:30 a.m. until 10:30 p.m. the group of fixtures belonging the program 1 must be
switched on 100%. The group of fixtures must then switch off. Enter the times as follows:
Time 1: The group of fixtures switches on at 6.00 a.m.
Time 2: From 6:00 a.m. until 6:30 a.m. the light power is gradually increased up to 100%.
Time 3: From 6:30 a.m. until 10:30 p.m. the group of fixtures remains switched on at 100%.
Time 4: From 22:30 p.m. until 23:00 p.m. the light power is gradually decreased down to 0%.
Times 5 to 8 can be entered if you wish for the group of fixtures to be switched on and off at
several times.
The first and last time must always be 0%. If this is not the case, the fixture will
remain switched on.
Linking lighting programs to groups
Have you created groups, assigned fixtures to groups and set lighting programs? You can now
link the lighting programs to groups in a few simple steps.
Set control light
The control light is the red LED lighting and is the minimum lighting for being able to monitor
the buildings at night without disturbing the animals in their day and night rhythm.
One program can be set for the control light. This program then applies to all the groups.
10