Connecting To Power Supply - Belle TUBMIX 50 Bedienungshandbuch

GB
5. Transport
The machine is easy to move. Lift the handle and
move the machine on its wheels, as shown in Fig. 8.
8 8

6. Connecting to power supply

Make sure that the switch is turned off before
inserting the plug.
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) or class
II isolation transformer
characteristics:
RCCB
230V In 10 A Id 20 mA
115V In 20 A Id 20 mA
N.B. To ensure correct functioning, periodically
check the efficiency of the RCCBs by pressing
the push-button on the front of the same.
Prior to connecting the machine to the power
supply, make sure that the voltage is the same as
indicated on the machine data plate. The machine
must be connected to an effective earth wire. In
case of doubt, do not connect the machine.
INFORMATION
Please be aware that when the mixing head and
agitator are raised out of the mixing tub an
automatic safety switch is engaged preventing the
operation of the motor.
with the following
Transformer
230 V 50 Hz 1500 W
Cont. duty
115 V 50 Hz 1500 W
Cont. duty
THE MOTOR SHOULD ONLY BE RUN IN THE
MIXING POSITION
POSTIONED WITHIN THE MIXING TUB.
The TUBMIX are provided also with overheat
protection with manual reset. This intervenes in the
event of the agitator jamming. In the event of it
jamming, before resetting the thermal protection,
disconnect the machine from the mains electricity
supply and empty the basket partially.
9 9
7. Preparation of the mixture
Proceed as follows to prepare the mixture:
• Always start the machine only when it is empty.
• Proceed as follows or as directed for the type of
material to be mixed.
CAUTION !
Adhesive for floor and wall tiles
A) Carefully read the instructions on the glue sack
you are going to use.
B) Pour in the tub the quantity of water necessary
to prepare the desired adhesive quantity
following the manufacturer's instructions.
C) Start the TUBMIX 50, then tip the first 25 kg of
powder at a speed of 10 kg/min directly on the
plastic protection, which will centrifuge the
material to obtain an appropriate mixture.
Continue with this operation in a continuous and
uniform manner with the second sack (25 kg)
and wait for the whole product to be properly
mixed. In this way the mixture will be free from
lumps.
4
WITH THE AGITATOR