Lavorwash SKYVAP Bedienungsanleitung Seite 50

EN
floor.
• Wax-treated tiled floor (wax removal)
• Tiles or tiled walls
• Roller shutters, guillotine windows
• Carpets
Small surfaces, such as:
• Interstices of
skirting boards
• Door or window frames
• Shutters
Glass surfaces, such as:
• Windows, glass walls
• Glass doors
• Mirrors
Upholstery, such as:
• Carpets and moquettes
• Upholstered furniture (sofas, airmchairs).
•ATTENTION!
Furniture surfaces can be treated with the steam
cleaner under the following conditions:
• Never clean with the direct steam jet.
• Always use a soft absorbent cloth
• Work with little steam pressure
• When you clean, don't exert any pressure with
the brush.
Assemblying of wheels and handle
• Assemble wheels by hand as shown in picture
on fig. B . No tool is required.
• The handle (13) must be fitted on the upper
part of the appliance with 4 screws (included in
the accessories supplied) (see picture on page
II). You will need a screwdriver for this operation
(not included in the accessories supplied).
Assemblying of the holding hook
• For a comfortable use of the two extensions,
assemble the holding hook (29).
• The holder must be fixed with screws (included
in the accessories) under the extensions (see
picture fig. B)
Starting the steam cleaner
Fill with water
50
heat radiators, tile joints,
(fig. E)
•ATTENTION!
• Before filling the boiler with water, unplug the
machine.
• Fill in the steam cleaner only with distilled water
or with tap water with low mineral contents.
• The formation of limescale in the machine can
cause the machine to overheat and clog the
steam outlet pipe.
• The steam cleaner must rest on a plane
surface.
- Press the boiler cap (9) downwards and turn
it anticlockwise at the same time, so as to
unscrew it completely.
- Pour a suitable amount of water (min. 0.5 l,
max. 1.6 l) using the provided jug and funnel.
- Put the cap on the boiler: press it downwards
and turn it clockwise at the same time, so as to
screw it tight.
•WARNING!
• Make sure that the boiler cap is properly closed.
Cap loosening during use may cause scalds!
Connecting the steam cleaner
DANGER!
(fig. C)
• Connect the machine only if the mains voltage
matches to the rated voltage marked on the
rating plate.
• The main switch (4) must be disconnected (OFF
position).
• The power cord (10) must not be damaged.
• The water tank must be filled with a sufficient
water quantity (min. 0.5 l) using the special
measuring jug.
• The hose must be connected to the relevant
accessory.
• The steam nozzle must not be obstructed.
- Press the main switch (4); the indicator lights
(4/B and 5) come on (heating begins).
- The machine is in operation.
- Water is heated and steam is generated.
- When the green lamp lights up (3) the machine
is ready to work.
Pouring water into the boiler
WARNING!