Handpresso auto Bedienungsanleitung Seite 6

1 2
5 6
8 9
11
2'
bip x3
14
16
10
3
4
12 V
7
10
OK NO
OK NO
12 13
12 V
15
17 18
instructions
for ground coffee
1 – Before using Handpresso Auto, make sure that the
vehicle is stationary, the parking brake engaged and the
engine turned on.
2 – Uncoil the power cord before installing Handpresso
AUTO vertically in the cup holder.
3 – Plug the power cord to a 12V cigarette lighter plug.
4 – Unscrew the portafilter.
5 – Place the ground coffee ring in the pod holder if it is
not there.
6 – Fill the cup with water up to the black line, then pour
the water in the machine.If you do not have the cup,
beware not to pour too much water ! Therefore, watch the
water level indicators. They get darker clockwise, the one
after the other, as you add water. Pour slowly. Stop adding
water as soon as the last indicator turns black.
7 - Prepare your coffee dose by filling the ground coffee
adapter evenly with the espresso coffee of your choice.
Please check that the coffee does not exceed the upper
edge of the ground coffee adapter. Please refer to "some
useful recommendations" on p.12 to optimize the filling
and the tamping of the ground coffee adapter.
8 – Put the ground coffee adapter in the ground coffee
ring.
9 – Close the ground coffee portafilter by rotating it 60
degrees clockwise... up to the locking indicator. Beware:
the brewing will not be possible if the ground coffee
portafilter is not properly locked!
10 – Press the ON button to start the heating cycle of the
machine.
11 – Wait until you hear 3 bleeps (approx. 2 minutes).
Beware: When the motor noise stops, it does not mean
that the machine is ready! Wait until you really hear the
machine bleeps three times. At the end of the cycle, when
the machine is ready, the thermometer will show the
correct water temperature and the ON button will remain
lit for 1 minute.
12 – Unplug the machine.
13 – Flip the machine around, place it over a cup and
push the espresso button till the end (a safety ring
appears) to pour the coffee.
14 – When the cup is filled to your liking, press the STOP
button - until the safety ring disappears – in order to stop
the coffee.
15 – Turn over the machine and place it back vertically in
its housing.
16 – Re-open the ground coffee portafilter and remove the
ground coffee adapter. Remove the brewed coffee from
the ground coffee adapter by squeezing the sides and
pressing the mesh filter. Throw out the coffee and rinse
the ground coffee adapter. Beware of the water which may
still be in the water reservoir.
17 – Pour out any excess water from the water reservoir.
18 – Enjoy your espresso.
To prepare the second espresso, go back to step 4.
11