Babyhome Vida Stroller Montageanleitung Seite 18

ning positions. This mechanism works
as follows:
To raise the seat, pull the strap parallel to the
seat, as shown in illustration 14a. Stop pulling
when the seat reaches the desired position or
when the mechanism reaches as far as it can.
To recline the seat, lift the knob and gently
lower the seat to the desired position. Once
you release this knob, the seat will remain
in place (illustration 14b). Remember that
pulling the strap in one direction is not
recommended and forcing the knob can lead
the mechanism to work improperly.
Use of the hood
Once the hood is attached, you can fold it or
unfold it in different positions by using the
piece located on each side (illustration 15a).
The upper part of the hood has a window that
EN
can be uncovered by pulling back the covering
fabric.
You can remove the hood by moving the two
anchoring pieces in the direction shown in
close-up 2 of illustration 15b. You can extend
the hood using a zip located in the hood lower
part to protect your child better from the
damaging effects of the sun.
Handlebar positions
You can adapt the handlebar positions by
pressing both side buttons located at the top
structure at the same time (illustration 16b).
Installing the rain protector
To put up the rain protector properly, put it
over the hood (see close-up of illustration
16) according the specifications in the image:
passing the velcros through the seat structure
(illustration 16). Attach the rain protector to
18
the structure using the provided
connection systems: velcros and brackets.
You can remove the rain protector following
the same procedure reversing this sequence.
Installing the mosquito net
To put up the mosquito net properly, guide it
through the zip placed on the hood structure
using the pieces located in both sides.
Attach the mosquito net to the structure
using the velcros through the seat structure:
velcros and brackets. You can remove the
mosquito net following the same procedure
reversing this sequence.
Canopy Extender
Install the canopy extender joining the zip
placed on the canopy stroller limit with the
canopy extender by the zip side. This stroller is
designed to be used by a single child.
Open and close the harness
Locate the two superior buckle of harness.
Push the buttons of each buckle to release
the harness. To fix the harness again, you must
join again both parts of buckles.
Regulation of height harness
To regulate the height of harness, pass the 2
superior finishing of harness through the holes
from the backrest. You can adjust the height
in 3 different
positions. Once you decide which height is
more convenient for you, pass through again
each finishing to the holes from backrest to fit
the harness.