Babyhome Vida Stroller Montageanleitung Seite 17

Instructions for use
Folding the Vida pushchair
In order to fold the chassis, press the release
button located on the front left side of the
handle and then lift both levers located on the
back. Use illustration 5 as your guide to the
proper movements.
Once you have all the buttons pushed, the
chassis is released – held by the handle – and
you can rotate the upper chassis towards the
back wheels in the direction shown in
illustration 6. Make sure that the folding
obstructer is attached as shown in the
close-up of illustration 6.
The pushchair can be folded in two ways:
-If you leave the front wheels as shown in
illustration 7, you can leave the pushchair
standing when folded.
-However, if you fold them as shown in the
close-up of illustration 8, you can place it
inside the transport bag and pull it so that it
rolls on the back axel (illustration 8).
Remember not to activate the brake if you
choose this option.
If you would like to make the folded pushchair
smaller, we recommend that you remove the
front and back wheels, as shown in
illustration 9. First, press the stopper and
then remove the wheel. The pushchair can be
folded with or without the hood. You will be
unable to fold the pushchair properly if the
front wheels are in the blocked position.
How the brake works
The brake is activated using the pedal located
on the pushchair's back wheel. To stop the
pushchair, gently press on the back of this
pedal, as shown in illustration 10a. The brake
works simultaneously on both back wheels. To
release the brakes, press the same pedal on
the back, as shown in illustration 10b.
Blocking the front wheels
The front wheels can be prevented from
rotating if they are blocked using the safety
button located behind each axel (illustration
11). If the safety button is lowered (position 0),
the wheels can rotate freely, but if it is raised,
the wheels are blocked and cannot rotate
around the axel (position 1).
Regulating the footrest
The footrest has two different positions. You
can change it to the lower position by raising
it until you hear the click. If you wish to put it
back into its original position (illustration 12),
press the buttons located below the seat (1)
and rotate the footrest (2).
Securing your child
Remember that your child should be secured
using the 5-point harness as soon as you seat him
or her in the Vida pushchair (illustration 13).
Slide the middle belt (1) between your child's
legs and put his or her arms between the
shoulder belt (3) and the waist belt (2). Once
you have done this, join these three belts
using the harness restraints. Make sure you
hear a click, which will indicate that everything
is properly secured. The secondary harness
(4) could be used to add an additional safety
system. To open up the harness, press both
buttons located on either side of the harness
restraints together. Regulate the belts so they
are snug on your child. To adjust the length
of the belts, slide the buckles up or down.
Remember, too, that the shoulder belt has
two lengths.
Reclining positions
The Vida pushchair comes with a mechanism
located behind the seat to regulate the recli-
EN
17