Operation - Carpoint 0623236 Benutzerhandbuch

WaRNiNg
Please carefully read the manual included with this product. Misuse of the unit could cause property /equipment
damage and/or personal injury.
1. Do not overinflate products beyond manufactures recommendations.
2. Do not allow the compressor or its components to get wet.
3. Do not leave the air compressor unattended while in operation.
4. Do not allow children to handle or operate this compressor.
5. Do not use this product for other than its intended use.
6. Do not disassemble or tamper with this compressor.
7. Inspect air compressor before use. If cracked, broken or damaged parts are found, qualified technicians should repair damaged parts.
8. Never expose the air compressor to rain, frost or temperatures above 30°C (86°F) or temperatures below -30°C (-22°F).
9. Never use on people or animals.
10. Make sure the cord is not exposed to hot objects, oil or sharp edges.
WaRNiNg!
For your own safety, you should only use accessories and parts specified in the instructions, or recommended for use
by the manufacturer.

OPERatiON

This product is equipped with a programmable digital pressure gauge. The digital gauge can be used to monitor air pressure when
inflating your objects, and can automatically shut off once pre-set desired pressure is reached.
PRESSuRE PRE-SEt
the pre-set pressure is factory set at 40 PSi (2,7 BaR) when manufactured.
1. Press button 'set' for 3 seconds to check the pre-set pressure. The pre-set pressure is factory setted at 40 PSI (2,7 BAR) when
manufactured.
2. Adjust your desired pressure by pressing button ' p '/ 'q' . Press Button 'p' to increase the pressure gauge and press Button 'q'
to decrease the pressure gauge. Once the desired pressure is reached, the displayed figure will light up for several times, then return
to 0,0PSI. That means the pressure is preset successfully. The product is ready for inflating.
3. Press button 'set' to read press gauge by PSI/BAR.
iMPORtaNt
1. the product records latest pre-set pressure. For example, if your pre-set pressure gauge is 35 PSi, the product
records the pre-set pressure at 35 PSi.
2. Before reaching desired pressure, the compressor can shut off manually by moving the On/Off switch
to 'i' position.
iNFlatiNg tiRES
1. Roll out the 12V cord and connect the 12V adaptor to the outlet.
2. Screw the thread connector onto tire's valve stem.
3. Adjust the tyre to desired pressure. (Refer to pressure pre-set)
4. Move the On/Off switch to 'I' position and the compressor will start to operate. The compressor will automatically shut off once the
pre-set pressure is reached.
5. When car tire or bicycle tire pressure reaches preset pressure, the air compressor will stop automatically.
6. Remove the thread connector from the tire and disconnect the 12V car adaptor.