PianoDisc PDS150 Bedienungsanleitung Seite 12

Using PDS Power Speaker Controls
Using PDS Power Speaker Controls
Power on/off switch.
This switch is located on the back panel of the
speaker. Pushing the button to the ON position turns on the built in
amplifier. The green LED light will illuminate to indicate that the power is
on. The power can be left on all the time since the speaker will go to a
low power stand-by mode after one minute of no music input. If you will
be away for an extended period you can push the button to the OFF
position.
Volume control.
This is used to set the maximum volume for a given
input level. For portable sources such as personal CD players that have
their own volume control set the speaker volume to about ¾ of full
clockwise position. The volume control on the source will then be used
to set the listening volume. For fixed line out sources you can use the
speaker volume control to set the desired listening volume.
Tone controls.
These controls let you adjust the amount of high
(TREBLE) or low (BASS) frequency volume there is compared to the
rest of the music. Adjust these controls along with the volume to get the
sound that you desire.