PianoDisc PDS150 Bedienungsanleitung Seite 10

Connecting to a PDS Powered Speaker
Connecting to a PDS Powered Speaker
1.
With the power switch still in the OFF position plug the AC
power cord into the socket labeled AC~IN.
2.
Plug the AC power cord into a household wall outlet. Note that
the plug only fits in the outlet one way. Do not defeat this
polarization.
3.
Connect one end of the 2.4 m long audio cable supplied with the
speaker to the INPUT jack on the speaker.
4.
Connect the other end of the audio cable to the source. This can
be done in one of two ways:
a. Connect directly to either the right or left channel "tape out"
RCA connector on most audio system sources, such as
preamps, amplifiers, receivers, VCRs, etc. (Note: your
source may use different terminology such as: "audio out,"
"direct out," "line out," etc.)
b. For portable sources such as portable CD players you will
need to use a 3.5 mm stereo to RCA plug adapter. Plug the
audio cable into the adapter RCA jack then plug the stereo
3.5 mm plug into the earphone jack of the source.
5.
If you have two PDS speakers for full stereo sound, connect as
follows:
a. For audio system sources simply connect the second
speaker to the other channel output on the system. Place
the speaker connected to the red jack on the right of the
listening position.
b. For portable sources you will need to purchase a cable that
has a stereo plug on one end and two RCA plugs on the
other. Connect the red RCA plug to the right speaker and
the white plug to the left speaker.