Start Up / Use; Installation (Fig A - C); Switching The Product On / Off; Changing The Water / Maintenance / Cleaning / Care - Melinera HG00214A Bedienungs- Und Sicherheitshinweise

Start up / use

Installation (Fig A ‒ C)
Q
Fill the water container
MAX (inside wall) with distilled water.
Push the LED over the supply hose
connection between the supply hose and the
decorative attachment. The LEDs must face in
the direction of the decorative attachments.
Note: Put the supply hose
in the supply nozzle.
Put the decorative attachment with the base
plate and the attached pump into the water
9
container and lead the mains power lead
through the notch on the back of the base plate.
Note: For model HG00214D:
Place the glass ball
of the decorative attachment (fig. C).
Your product is now ready for use.

Switching the product on / off

Plug the mains plug
light up and water flows from the product.
For model HG00214D:
After the pump has started to pump water, move
the glass ball a little to obtain an optical
11
effect.
Unplug the mains plug from the mains to turn
off the product.
Changing the water /
Maintenance / cleaning / care
LIFE BY ELECTRIC SHOCK! Pull
the mains plug
before carrying out any work on the product.
Always use distilled water to avoid the build up of
lime scale!
up to the marking
7
to the
1
of the pump
1
5
on the water jet opening
11
into the mains. The LED
6
DANGER TO
out of the socket
6
Note: Water can be evaporated during operating,
fill the water up to "MAX" when water level fall to
"MIN".
Note: To avoid the build up of algae you should
clean regularly change the water and and clean
the water container
at regular intervals - at least once a week.
10
Remove the base plate
orative attachments
Pull the supply hose
nozzle .
3 2
After removing the supply hose
the LED from supply hose
8
Lie the base plate and decorative attachment
carefully together with the LED
Carefully pour the water out. Clean the water
container with a soft cloth (or similar) use a
little cleaning agent if necessary. Clean the
decorative attachment
similar) use a little cleaning agent if necessary,
alternatively you may use a duster. Duster can
also use to clean the grooving of the outer side
of the product, supply hose
supply nozzle
Fill the water container up again to the MAX
mark (inside wall) with distilled water.
Rebuild the product again (see „installation").

Disposal

The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities. The Green
Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
and decorative attachment
7
together with the dec-
9
from the water container.
10
out of the supply
1
, the pull off
1
.
1
and pump
8
with a soft cloth (or
10
and surface of
1
.
2
.
3
GB 9