manager or a qualified electrician if you are
not sure what type of power is supplied to
your building.
Caution – Not all power cords have the same
current ratings. Do not use the power cord
provided with your equipment for any other
products or use. Household extension cords
do not have overload protection and are not
meant for use with computer systems. Do not
use household extension cords with your Sun
product.
The following caution applies only to devices with a
Standby power switch:
Caution – The power switch of this product
functions as a standby type device only. The
power cord serves as the primary disconnect
device for the system. Be sure to plug the
power cord into a grounded power outlet that
is nearby the system and is readily accessible.
Do not connect the power cord when the
power supply has been removed from the
system chassis.
The following caution applies only to devices with multiple
power cords:
Caution – For products with multiple power
cords, all power cords must be disconnected
to completely remove power from the system.
x
Sun Storage F5100 Flash Array Safety and Compliance Guide • May 2010
Energy Storage Module Warning
Caution – There is a danger of shock or
equipment damage if energy storage modules
(ESMs) are mishandled or incorrectly
replaced. When replacing an ESM, use only an
ESM that has been provided by Sun
Microsystems using the instructions provided
in the product service manual. Do not
disassemble ESMs or attempt to recharge them
outside of the system. Do not dispose of
ESMs; return them to Sun Microsystems, in
accordance with the procedures outlined in
the Sun Storage F5100 Flash Array Product
Notes.
System Unit Cover
You must remove the cover of your Sun computer system
unit to add cards, memory, or internal storage devices. Be
sure to replace the cover before powering on your computer
system.
Caution – Do not operate Sun products
without the cover in place. Failure to take this
precaution may result in personal injury and
system damage.