How To Use Your Dryer - Hotpoint AQUARIUS TL64 Bedienungsanleitung

How to use your dryer

1. Plug in, switch
on electricity.
3. Open the door.
Check that the fluff
filter is clean. Lift
filter upwards, clean
away any fluff,
replace filter
correctly.
5. Select the
relevant heat setting
(see section "The
Controls"). When
low heat is selected
(switch in out
position) the green
indicator mark is
visible. Automatic
programs will NOT
function on Low
Heat.
7. When finished,
open the door and
take out the laundry.
Clean and replace
the fluff filter.
8
WARNING: WHEN
SWITCHING ON OR
OFF, PLEASE
ENSURE THAT
YOUR HANDS ARE
DRY
Button Out
LOW HEAT
Button In
HIGH HEAT
2. Sort your laundry
(see section "Sorting
Your Laundry")
4. Load the dryer,
placing the clothes
carefully in the drum
pushing them well
towards the back
and away from the
door seal. Close the
door.
6. Select drying
time required.
Automatic drying,
average loads
Automatic drying,
large loads . OR
Timed Drying of up
to 70 minutes for
small loads or low
heat settings.The
dryer will start
(providing a delay
time has not been
set). See section
"The Controls".
8. Switch off
electricity and
remove plug from
socket.
WARNING: WHEN
SWITCHING ON OR
OFF, PLEASE
ENSURE THAT
YOUR HANDS ARE
DRY