How To Remove And Clean The Fluff Filter - Hotpoint AQUARIUS TL64 Bedienungsanleitung

How to remove and clean the Fluff Filter

Position of front filter
To remove the filter
12
A very important part of your Dryer is the Fluff Filter at
the front edge of the drum. It's there to trap the
particles of lint and fluff which are normally blown away
when clothes are dried on the washing line.
If the filter is allowed to become blocked, the passage
of warm air through the drum will be severely
restricted. This means your clothes will take much
longer than normal to dry and the cost of drying them
will be increased. It may also damage your machine.
Small items, e.g. babies socks, may fall onto the filter.
These should be removed so that the filter is not
restricted.
Grip the plastic handle and pull filter upwards (see
diagram below). The fluff that has collected can now
be removed.
Wash or vacuum clean the filter occasionally.
Don't be alarmed by the amount of fluff you may find
on the filter. It's part of the wearing, washing and
drying process.
Lift to
remove
filter
It is essential that the filter is replaced correctly, with
the words 'LIFT TO REMOVE FILTER' facing you.
Ensure the filter is fully located flush into the tumble
dryer trim.
WARNING: DO NOT OPERATE THE DRYER
WITHOUT CLEANING THE FILTER AFTER
EACH DRYING CYCLE. FAILURE TO CLEAN
THE FILTER MAY RESULT IN A FIRE HAZARD.
WARNING: DO NOT OPERATE THE DRYER
WITHOUT THE FILTER IN POSITION