Lanaform AQUA PLEASURE Handbuch Seite 9

B. EXTERIOR INSTALLATION
• Wherever you choose to install the spa bath, it must be positioned on a solid surface. If installing the spa bath outdoors,
ensure that there are no sharp objects which could damage it, and that the area is level and stable. Prevent dirt and
debris from collecting in your spa bath by placing a mat beside it on which to wipe your feet before entering. You might
also consider placing a small basin of water nearby, in which bathers can rinse their feet before getting into the tub.
• When filling, emptying or using the spa bath, there is the chance of water spillage. The tub should therefore be installed
near a ground drain.
• Do not allow the surface of the spa bath to be exposed to direct sunlight for long periods.
C. CHECKING THE CIRCUIT BREAKER
NOTE:
Before each use of your spa bath, it is essential to test the RCD circuit breaker supplied. It is also important to
ensure that the device is set to a residual current not exceeding 30mA.
1. Insert the circuit breaker plug into the power socket. (diagram 2.1.)
2. First press the "Reset" button. Check that the indicator light is red. (diagram 2.2)
3. Next press the "Test" button. The indicator light should go off. (diagram 2.3.)
4. Press the "Reset" button again. The indicator light should be red. (diagram 2.4.)
If all the above steps go smoothly, the spa bath is ready for use and the LCD screen will light up.
D. ASSEMBLY
1. Spread out the spa bath and cover, checking that the holes are lined up (diagram 3.A.).
2. Connect one end of the inflator hose (diagram 1.E.) to the black pump adaptor (diagram 3.B.).
3. Check the RCD circuit breaker plug as described in point C and then press the massage button to activate the pump
(diagram 3.C).
4. First inflate the bottom chamber of the spa bath and then the main air chambers, starting with chamber 1 and
finishing with 3 (diagrams 3.D.1. & 3.D.2.). It is advisable to only inflate the main chambers to 80% capacity at
first, to allow you to adjust the shape and check that all the adaptors are correctly positioned, before completing the
inflation.
WARNING:
Only use the pump provided to inflate the spa bath. Do not use high pressure pumps, which could burst
the tub and cause damage or injury.
How to use the main chamber valves
- Open the first valve cover, insert the end of the inflation hose and inflate the chamber (diagrams 4.A. and 4.B.).
- When the chamber is fully inflated, replace the valve cover (diagram 4.C.).
- To deflate, simply pull back the valve cover fully (diagram 4.D.).
WARNING:
Ensure that the pump is fully disconnected from the power supply before connecting it to the spa bath.
5. Connect the pump to the spa bath (diagram 5.A.1.).
Attach the different pump adaptors to the bath adaptors, ensuring that the colours at the ends correspond. Connect
each of the two black hose connectors to the black ends of the pump and the spa bath. Check that the joints are secure
and tighten the adaptors manually to ensure a good fit.
6. Place the filter in the housing provided. To do this, open the cover at the top of the pump (diagram 5.B.1; 5.B.2) by
turning it anticlockwise. Put the filter in place and close the cover.
7. Fill the spa bath using a garden hose, ensuring that the level of water reaches the marker on the inner wall of the spa
bath (diagram 5.C.).
Aqua Pleasure
EN
9