CANGAROO X55P02AS-D Bedienungsanleitung Seite 14

This sterilizer can fit up to 6 standard neck bottles from any brand and 4 wide neck bottles, as well as
other baby feeding items, for e.g. feeding bowls, cups and spoons.
The product can be used and for sterilizing accessories, which come into contact with milk – such as
breast pump.
The appliance is multifunctional and except as a sterilizer, it can work as a sterilizer and food steamer
(fruits, vegetables, eggs and etc.).
A. Sterilization:
1. Measure exactly 80 ml of water and pour into the reservoir in the base of the unit.
2. Put the main body of the sterilizer on its base and place the feeding bottles on the relevant stands
upside down.
3. After that place the tray on the main body and put inside the pacifiers and other small accessories.
Make sure that all parts which must be sterilized are completely disassembled, and that you have put
them with their openings facing down in order to avoid their filling with water. Note: Clean the bottles
and other items before sterilizing them.
4. Cover with the lid, plug the supply cord to the power outlet and turn on the switch.
5. Push the power button. The indicating light will illuminate, showing that the appliance is working.
6. When the sterilization cycle ends, the unit will automatically turn off.
7. Leave the sterilizer to cool down for 3 minutes. Turn off the switch and unplug the supply cord.
8. Take off the lid and leave the unit until the steam spreads out. After that take out the sterilized
objects. Using the clips, take the small accessories out. Be careful – the sterilized items may still be
hot. NOTE: Do not forget to wash your hands thoroughly before taking out the sterilized objects.
9. Take off all of the compartments of the appliance and pour out the residual water. Wipe dry the
sterilizer.
WARNING! Never open the lid during sterilization. If the process is being interrupted, the items will
not be sterilized.
Never use the sterilizer without water.
Note: If you put more water than the recommended dose of 80 ml, the process of sterilization will take
more time. But if you put less, then the sterilization will not be effective. The length of the sterilization
depends on the quantity of the items, which you have put in the unit. Usually the sterilization time is
approximately 6 minutes. Do not add more than 200 ml of water.
B. Warming bottles:
1.) Measure the quantity of water required following the guidelines in the table bellow and pour it into
the reservoir in the base of the appliance.
Please, note that this table is for guidance only. Many variables such as the size of the bottle or its
initial temperature can influence the speed at which the device can warm the bottle and the reaching
of the required temperature. Adjustments to the table guidelines may be needed.
35 ml
25 ml
showing that the device is running.
4.) After the sterilization cycle ends, the device will turn off automatically.
5.) Take out the bottle immediately from the unit. Shake it in order to distribute the heat evenly. Always
check the temperature of the fluid before feeding your baby by pouring small amount on the inner side
of your wrist.
6.) Turn the device off and unplug the supply cord.
7.) Take off the lid and the tray and pour out the residual water. Wipe dry the unit.
40 ml 45 ml
30 ml 35 ml
Always check the temperature of the milk before
feeding your baby.
2.) Place the tray on the base of the unit. Insert the
bottles inside the unit and put the lid on the top,
leaving the two openings open.
3.) Push the power button. The indicating light will
illuminate,
13