Control Panel; How To Use - Unilux R’CLEAN Bedienungsanleitung

Control Panel

Filters reset button
Power button
PM 2.5 Indicator
UV Lamp On/Off
buton

How to use

Start:
After main power is switched on, press the Power button. The Air Quality
indicator lamp will light up. It will run in AUTO mode.
Auto run mode:
Press the AUTO button when the unit is in another mode, it will go into the auto
run mode. In the AUTO mode, the auto indicator will glow and the unit
automatically adjust the air flow depending on the indoor air quality. The Air
Quality indicator lamp will glow to the corresponding level of air quality.
Colour of the ring
Air Quality
Sleep mode:
Press the SLEEP button after the start or in the other mode, it will go into the
sleep mode. In this mode the sleep indicator will light and the purifier will run in
speed 1 & speed 2.
Manual mode:
Press the AIR FLOW button after the start or in the other mode, it will go into
the manual mode. In this mode the corresponding speed indicator will light and
the air purifier will run in selected speed. You can change the speed by pressing
the air flow selector button.
Stop function:
If you want to switch off the air purifier completely press the POWER button, the
unit will switch off.
R'CLEAN air purifier
22
3
025
Air flow selector
Blue Green
Good Moderate
Timer display/ residual
life of filters display
Timer switch
Light On/Off
Auto mode button
Air flow indicator
Ions On/Off button
Sleep mode selection
Purple Red
Polluted Bad
EN
6