General Safety Instructions For Electric Tools - Heinner VSA003 Anleitung

Important!
When using equipment, a few
safety precautions must be observed to
avoid injuries and damage. Please read
the complete operating manual with
due care.
GENERAL SAFETY INSTRUCTIONS
FOR ELECTRIC TOOLS
Workplace safety
Keep your work area clean and
well illuminated.
Do not operate the electric tool in an
environment where there is a risk of
explosions and where there are
inflammable liquids, gases or dust. Keep
the electric tool out of the reach of
children and other persons.
Electrical safety
The connector plug from this
electric tool must fit into the socket.
Avoid bodily contact with earthed
surfaces such as pipes, heating,
ovens and fridges.
Keep the tool out of the rain and away
from moisture. If you are working
outdoors with an electric tool, only
use extension cables which are
designed specifically for this purpose.
Safety of persons
Do not use the tool if you are tired or
under the influence of drugs, alcohol
or medication.
Wear
EN
equipment and safety goggles.
Remove the keys and wrenches
before switching on the electric tool.
Wear suitable clothes. Keep hair and
clothes and gloves away from moving
parts.
Usage and treatment of the electric tool
Do not overload the appliance. Do not
use an electrical tool with a defective
switch.
Have damaged parts repaired before
using the appliance.
Keep your cutting tools sharp and clean.
Using and handling the cordless tool
Only charge the batteries in chargers
that are recommended by the
manufacturer.
In case of incorrect use, fluid may escape
from the battery. In case you touch it,
rinse the affected area with water.
Service
Have your electric tool repaired only
by trained personnel using only
PROPER USE
This tool is designed for fast screwing
and unscrewing of screws and cannot be
used as driller.
Technical data
Voltage: 3.6V (Li-ion) 1300MAH • No
Load Speed: 180rpm • Max.Torque:3
N.M • Charge Time: 3-5hours • Adapter -
Voltage: 230V/Frequency: 50Hz
Tool description
1 – Chuck • 2 – Work light • 3 – Work
light On/Off switch • 4 – Battery charge
personal protection