Kingfisher KI 3800 Serie Kurzanleitung Seite 2

QUICK REFERENCE GUIDE – KI 3600 Series Optical Power Meter
• To remove the connector adaptor, press the button
on the rear of the instrument and pull off adaptor. This
may be easier with a patch lead in place.
• To turn on the instrument, press [POWER].
• To defeat auto power-off, hold down [2nd] while
pressing [POWER]. 'Perm' is displayed on the top
right of the LCD.
• Low battery is indicated with a battery symbol.
• To scroll wavelength, press [ λ] or [λ
• To switch between absolute or relative display
modes, press [Abs/Rel].
• To stop / start display update, press [HOLD].
• To set reference, hold down [2nd] while pressing
[SET REF].
• To toggle log/linear display mode, hold down [2nd]
while pressing [dB mW].
• To display the max / min recorded power, hold down
[2nd] while pressing [Max Min]. To reset this function,
press and hold down [2nd] and [Max Min] for 3
seconds.
• If a test tone is detected, the detected tone frequency
is displayed in Hz.
AUTOTEST OPERATION
• To start Autotest, press [Autotest] on light source and
wait a few seconds. No user action is required from
the meter side.
• To display just one wavelength at the time on the
].
power meter, press [ λ] or [λ ]. Press [λ ] twice
to return to Autotest.
• Autotest remains for more than 8 seconds after signal
loss, to allow quick connection change.
• To exit Autotest, remove test lead or turn off light
source for more than
English
8 seconds.