Manual Operation - Kingfisher KI 3800 Serie Kurzanleitung

QUICK REFERENCE GUIDE – KI 3800 Series Optical Light Source
• To remove the connector adaptor, press the button
on the rear of the instrument and pull off adaptor. This
may be easier with a patch lead in place.
• To turn on the instrument, press [POWER].
• To turn on the source, press [SOURCE
• To defeat auto power-off, hold down [PERM ON]
while pressing [POWER]. 'Perm' is displayed on the
top right of the LCD.
• Low battery is indicated with a battery symbol.
AUTOTEST OPERATION
• For Autotest operation, an Autotest compatible power
meter or loss test set is required.
• To start Autotest, press [Autotest] on the light source
and wait a few seconds. No user action is required
from the meter side.
• Autotest remains for more than 8 seconds after signal
loss, to allow quick connection change.
• To exit Autotest, press [AUTO TEST] or [Menu].

MANUAL OPERATION

• To scroll wavelengths, press [SOURCE
• To set modulation, press [MOD KHz].
λ λ λ λ
].
• To adjust the laser power level, press and hold
[PERM ON] while pressing [MOD KHz] to increase or
λ λ λ λ
[SOURCE ] to decrease the output power.
This function does not operate when in Autotest and is
not available on the LED source option.
English
λ λ λ λ
].