Berger + Schröter 60432 Bedienungsanleitung Seite 8

Important steps for operation:
1. Drill holes in the workpiece to be riveted.
The size of the holes should correspond
with the size of the blind rivets.
2. Insert the blind rivet attachment device
such as bit into the drill chuck.
3. Hold the blind rivet attachment device
firmly in one hand and slowly start the re-
verse rotation of the drill until you hear a
"click". The jaws of the receiving device in
the blind rivet attachment are now open.
4. Choose the appropriate reception piece
for the selected blind rivet and mount it with
the enclosed installation wrench on the head
of the blind rivet attachment device firmly.
Now push the rivet into the tip.
5. Turn to clockwise operation. Verify that
the speed is not set too high.
6. Place the blind rivet attachment device
firmly on the workpiece to riveted and start
the machine in clockwise operation. Hold
the blind rivet attachment device and the
drill firmly with both hands. When the blind
rivet is completely in, the blind rivet attach-
ment automatically cuts of the rivet.
7. Turn the drill to reverse, hold with one
hand and let the drill run so long until the
rivet top is thrown out.
8