Technical Specifications - Like It PRO600 Anleitung Für Montage Und Betrieb

EN
SAFETY WARNING: After finishing the installation and all the settings of the operator (for
Professional installers only), a measurement of the operating forces and time to reverse the
garage door must be carried out, especially when the force setting is changed from default.
Without proper measuring equipment it is not possible to ensure it fulfills European standards EN13241-
1 & EN 12453. If permissible operating forces and the exposure times are exceeded, persons are
exposed to risks of crushing, shearing, entanglement, dragging and trapping in the opening and closing
movement of the door. Before start we advise reading chapter 7.
Attention in use
At the first time of using the door, please test
the driving system to see if it moves well.
(Test method: unlock the trolley, pull and
push the door by hand).
Use the remote control with the door in sight.
Do not stand or walk under a moving door.
The remote control should be out of reach of
children.
1. Functions
Control: one only button controls the open,
stop and close. The light is on while the door is
opening or closing, three minutes later the
light goes off automatically. The unit when
running is controlled by a program, that test
the force on the opening and closing
movement of the door, and also any other
optional security accessories. If the force to
close the door is too high, it stops and
reverses the movement. The functions for
protecting the engine are overload, over hot or
low power input.

2. Technical specifications

Power Input
Motor
Operating
Temperature
Relative Humidity
Open and close
force
41
DC motor: low noise, soft start, slow stopping to protect
the unit and insures a long lifecycle to the operator.
LED display: working situation is displayed on the LED
screen.
Decoding: rolling code.
Manual disengagement: Insures the door opening and
closing in manual mode (by hand) without electricity.
Optional functions: Photocells, wall push-button,
digicode, Flash light and Pass door kit for pedestrian
safety on opening.
220VAC±10% 50~60Hz Reception frequency 433,92MHz
24VDC
>-20ºC, <+50ºC
≤ 90 %
600N
Make sure the door away from fire, moisture,
electromagnetism and some other harmful
situations.
Check at least twice a year the door (follow
d o o r m a n u f a c t u r e r m a i n t e n a n c e
instructions) to make sure it is properly
balanced and that all working parts are in good
working condition. Adjust the chain tensile force.
Add suitable amount of lubricant to the system.
Decoding
Transmitter
power
Light
Courtesy light
time
Rolling Code
CR 2016 3V
Battery (x2)
LED
3 minutes
LIKE IT