Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12.
Output Connectors. Balanced XLR male line level output (Link) to connect an additional amplifier
without putting more load on the source. The signal won't be influenced by the filter / limiter /
volume settings of the amp.
13. LOW CUT Switch. selector switch to filter the low frequencies from the input signal. Choose from
three cut off frequencies; 15 Hz, 30 Hz & 50 Hz or off mode. This filter protects the cone from the
speakers against unwanted and inaudible low frequencies. The setup depends on the music type
and the surroundings where the amp is being used. Always have the filter switched on, unless
there are already filters already in the speakers, mixer, x-overs etc.
10
0
-10
-20
-30
-40
-50
-60
14. Speakon Outputs For Connecting Speakers. Maximum load in stereo/mono mode 2 Ohm per
channel. Maximum load in bridge mode 4 Ohm.
Pin +1 & +2 = + output, Pin -1 & -2 = - output
1
5. Master-Slave. For a delay start of more than one amplifier. Connect the amps as being showed
on the illustration, the out of the master to the in of the next amplifier. Put the switch of the first
amp on master and the other on slave mode. The slave amp will now be switched on delayed.
This prevents the start-up current for being too high.
16. Ground Lift Switch. Allows circuit and chassis grounds to be separated in case of problems with
earth loops (hum).
17. Fuse. This main fuse secures the amplifier and wires against defects. Replace this only with a
fuse of same type and value.
18. Mains Power Cord. Only connect the amplifier with a socket that has the same value as stated on
the type display.
Off
15 Hz
30 Hz
50 Hz
™
Werbung
